100 - 250 ml TFF Perfusion-SUB

Mini Perfusion-SUB integrating pump, Hollow-Fiber-Filter and sensor’s

World only P-SUB for TFF method offer

  • HFF (Hollow-Fibre-Filter) fouling free process with innovative diaphragm pump
  • 100 – 250 ml Working Volume fully pre-assembled P-SUB
  • Circulation of broth by Clio-CM80 diaphragm One-way-Single-Use-Pump (O-SUP)

General features of CellMembra™ mini P-SUB

  • No space consuming servo motor attached to the head plate - take advantage of Magnetic-Bottom-Drive (MBD) – fits to any Process-Control-System (PCS) with any servo motor
  • Designed with 4 x PG 13.5 head plate ports and 6 ports for In&Out with small diameter hoses
  • Pumped re-circulated broth volume fully programmable and obtained velocity accurately measured – no guessing
  • Spectrum CFF with pore 0.2 µm, 14 x 1.0 mm straw/lumen, 88 cm2 area, Luer-Lok side ports, (D02-P20U-10-N)
  • The complete and pre-assembled P-SUB unit packed in dual film bags and precision irradiated – forget the autoclave
  • SUB dim is OD 82 x 120 mm for Working Volume (WV) ranging from 100 ml up to 400 ml
  • Thermal control either electrical or with water - HSF available for 110 VAC, for 230 VAC, for water

Left photo show several CellMembra-500 of which one is supported in HSF-E and on MST for any servo motor drive. Center photo as mounted in liquid heated Heating-Support-Foot (HSF-W). The HSF helps stabilize the un-balanced weight distribution and improve temperature accuracy. Red Laser sensor mounted in a Re-Usable-Bracket above the dome of the Clio-CM80 O-SUP. Clotho Drive Unit requires only the cable to the LASER sensor and the blue pneumatic hose to drive the SUP.

Further P-SUB mini features

  • Comes with Magnetic-Bottom-Drive (MBD) for up to 250 RPM for use with MST
  • One pitch blade impeller
  • 3 small diameter weldable hoses length 600 mm 
  • 1 small short hose with 5 cm2 sterile filter for aeration
  • 1 small short hose with swabable valve for bottom sampling
  • 1 exhaust hose with 16 cm2 sterile filter
  • Need for liquid temperature control = Heating-Support-Foot (HSF)
  • Need for electrical temperature control = Heating-Support-Foot (HSF)

The 4 on the head plate available PG 13.5 ports are used for

  1. One port occupied by OneFerm pH Single-Use-Sensor (SUS)
  2. One port occupied by VisiWell Single-Use-Well (SUW) designed for VisiFerm (RUS) DO sensor
  3. One port free - available for 120 mm biomass Re-Usable-Sensor like PICO if available
  4. Suction trunk combines both In & Out for the SUP and level sensor for PCS connection